Car Battery Recharging

Car Battery Recharging: Simple Tips to Follow

Most of the times people embark on the process of Car Battery Recharging when the car refuses to start; however, most batteries will not necessitate a recharging five year in a trot. Provided you are taking good care of your car. Frequent recharges are indicative of the fact that your coveted car battery is in a poor state of health or there is negligence on your part. Batteries that have charge indicator are easy to deal with enabling you to find out the state of the battery.  In case it turns yellow or clear, you may have to recharge it at the earliest.    This piece of writing throws light on some of the simple guidelines on how to recharge your car battery.

Using a Trickle Charger

Trickle Charger

This device is capable of delivering electricity to your battery an external power source in a slow and steady manner. It is not usually necessary to charge your car fast.  A slow charging is much better because with this method batteries will be capable of holding a charge for a long duration. Generally, the trickle charger comes with an electric cord, a plug and two jumper cables with alligator clips.

Cleaning the Car Battery Recharging Terminals

Car Battery Recharging

In the process of battery recharging, you need to check the terminals of the battery and clean them. Make sure not to touch the terminals if you find the presence of whitish powder. This is dried sulfuric acid and you may risk a skin burn by touching it with bare hands. The best way forward is to use a manual sandpaper pad for wiping around the terminals, or getting a wet cloth and applying a layer of baking soda to the cloth.  Take utmost care for preventing any direct contact with the solution. Next, rub the terminals down with your removal system, which will be ensuring that they are ready to receive the wires.   

Removing the Cell Caps

Removing car Caps

These are a cluster of small caps that need to be removed prior to initiating the process of car battery charging.  You can find these caps either on top of the battery or under a yellow strip that could be peeled on and off. Some of these may not have caps at all. In case your battery has cell caps they must be removed before you begin charging. This will allow the gases formed during battery charging to escape into the environment.  

Attaching the Charger Cables

attaching charger cables

Before the process begins, you need to ensure that the car is turned off and successively the cables or the wires to the matching battery terminals.  Normally, a charger has two wires. Make sure to connect the red wire to the red or positive terminal. You need to remember that it might be labelled as the POS terminal on the Car Battery Recharging.  The other one is connected to a negative terminal or the terminal marked as NEG. These two wires should not be in touch with one another so that they do not cause a causing ignition of the hydrogen gas that surrounds the battery. You may suffer a nasty burn or it may even cause an explosion.

Turn on the Charger

Turn Charger

After connecting both the terminals, you need to connect the charger to the electric outlet.  Turn on the current and the battery will start charging itself. For best results, you can keep the charger on overnight.  In the morning, you need to turn off the charger and take a note of the reading on it.  If the reading is less than an ampere then you can unplug the charger.

Check the Battery

Check Battery

Once the charging has been completed, check for its working. In this process, you can use a hydrometer for finding the amount of electric energy in the fluid or else you can turn on the engine. In case the Car Battery Recharging does not turn on, then you need to replace it.

Leave a Reply