40
Advertisements

It is a known fact that every tree needs a good amount of water to survive and grow healthily, 10 gallons for every inch of trunk diameter to be precise. So, if you quickly run a calculation you can now find out the exact amount of water your young tree will need as per that. 

However, a tree can survive on a lot less water from that given you have been taking care of it in the right manner and watering the tree as per its needs. It’s time to learn the right tricks and save up on your water. 

If there’s a damaged or dry tree in your lawn which you have been watering ever since the probability is that the tree is dead and, in this case, it is advisable to contact tree services Sydney and get it removed. As you have just learned moments back about the quantity of water you need just by a simple maths calculation. 

Most of the tree’s roots can be found in the first ten to fifteen inches of the ground only especially in city areas where the constant construction and various other factors have made the trees adapt in a situation where the roots don’t grow deep in the soil. 

So, make sure you are watering your tree deep up to that level, and keeping the pace of the water slow will bring the best result as it will allow the soil of that area to absorb the water more efficiently rather than just flowing off where it can’t be beneficial for the roots. 

Let’s take a look at the correct measured methods in which you can plant and keep your tree happy:

1. Garden Hose

Trees consume a lot of water and it can be a tiring process if you pay attention water to each one of them specifically. This said, even if you have limited trees and you can spend time with your trees while watering them with a hose there are chances that sharp high pressure of it might be replenishing the upper layer of the soil and the tree is unable to absorb any water due to the fast-paced water flow. 

Instead, just start the watering process with slow-paced water that is just dribbling out, keep it near the tree, and keep shifting it to the other one every fifteen to twenty-five minutes. 

Keep a note of the fact that bigger trees will be needing more water and watering too much in the smaller trees can damage it. Maintain a timer for every plant or tree in this manner. 

Advertisements

2. Hose Connection

Another potential method for watering is by using a hose connection and place it under the shade of the tree. The hose connections are built in such a manner that it keeps dripping out water through small holes promptly which will increase the absorption performance by the soil and the amount of water gets wasted in this case gets very low. 

However, one should know the pattern (usually circular is preferred) in which they have to place the hose connection under the shade of the tree and keep it there for an hour or more. 

The main motive we are looking here for is the water to reach eight inches deep into the ground, and this can be tested by using a screwdriver called the screwdriver test. 

In this, you insert an 8-10-inch-long screwdriver to the ground and if it goes in all without any resistance then the nearby soil is well moist.

3. Driplines

This is hands down the most preferred way of watering the tree amongst all the other methods due to its ease of use process. Installing the drip lines needs some time and attention but it is all worth the efforts in the end. 

Just like the hose connections, a dripline needs to be set in a circular pattern under the shade of the tree and left to drip the water for an hour or more based on the size of the trunk, type, and weather conditions. 

4. Water Sprinklers

Water sprinklers are the most common watering system amongst the gardens, lawns, and parks. Installing this is a brain exhausting process just like the drip line but the result allows you to sit back and enjoy why the automated process of watering the trees also can be adjusted according to the size of the tree and weather conditions makes things easier for you.

5. Mug and Bucket

Old ways are the best way to go while watering your tree. This mug and bucket method doesn’t take much of your time, effort, or equipment expenses. 

You can simply choose a big enough bucket that you can carry around in the garden with few small holes in the bottom and then simply place it under the tree shade and keep changing the location until a tree has received sufficient water.

Advertisements

Like it? Share with your friends!

40
Aarti Thakur

0 Comments

Your email address will not be published. Required fields are marked *

Open chat
1
Hello!
Can we help you?
Powered by
Choose A Format
Story
Formatted Text with Embeds and Visuals